What Ondansetron Teva contains
- The active ingredient is ondansetron (as ondansetron hydrochloride dihydrate). Each ml of solution contains 0.16 mg ondansetron (as ondansetron hydrochloride dihydrate).
50 ml Ondansetron Teva solution for infusion contains 8 mg of ondansetron (as ondansetron hydrochloride dihydrate).
100 ml Ondansetron Teva solution for infusion contains 16 mg of ondansetron (as ondansetron hydrochloride dihydrate).
200 ml Ondansetron Teva solution for infusion contains 32 mg of ondansetron (as ondansetron hydrochloride dihydrate).
- The other ingredients are citric acid (E330), sodium citrate (E331), sodium chloride and water for injections.
What Ondansetron Teva looks like and contents of the pack
Ondansetron Teva is a clear, colourless solution, free from visible particles. It comes in a plastic infusion bag fitted with one infusion port closed with a rubber stopper and snap cap. The infusion bags are contained in an aluminium overpouch.
Pack sizes: 50 ml solution in multipacks containing 5, 10 or 30 bags 100 ml solution in multipacks containing 5, 10 or 30 bags 200 ml solution in multipacks containing 5 or 10 bags
Not all pack sizes may be marketed.
In het register ingeschreven onder: RVG 111276
Marketing Authorisation Holder and Manufacturer
Marketing Authorisation Holder
Teva Nederland B.V.
Swensweg 5, 2031 GA Haarlem
Nederland
Manufacturer
Teva Pharmaceutical Works Private Limited Company
Táncsics Mihály út 82.
H-2100 Gödöllő,
Hungary
Pharmachemie B.V
Swensweg 5, 2031 GA Haarlem
The Netherlands
This medicinal product is authorised in the Member States of the EEA under the following names:
<[To be completed nationally]>
This leaflet was last revised in maart 2013.
<-----------------------------------------------------------------------------------------------------------------------------
The following information is intended for healthcare professionals only: Instructions for use, handling and disposal:
How to prepare and administer Ondansetron Teva
For single use only. Remove overpouch only when ready to use, then check for minute leaks by squeezing the bag firmly. If the bag leaks, do not use as sterility may be impaired. The solution should be visually inspected prior to use and only clear solutions, without particles should be used.
Ondansetron Teva solution for infusion is compatible with Sodium chloride 9 mg/ml (0.9%) solution for injection.
Compatibility with other drugs: Ondansetron Teva may be administered by intravenous infusion at
1 mg/hour, e.g. from an infusion bag or syringe pump. The following drugs may be administered via the Y- site of the ondansetron giving set for ondansetron concentrations of 16 to 160 micrograms/ml (e.g.
8 mg/500 ml and 8 mg/50 ml respectively);
Cisplatin: Concentrations up to 0.48 mg/ml (e.g. 240 mg in 500 ml) administered over one to eight hours. Carboplatin: Concentrations in the range 0.18 mg/ml to 9.9 mg/ml (e.g. 90 mg in 500 ml to 990 mg in 100 ml), administered over ten minutes to one hour.
Etoposide: Concentrations in the range 0.14 mg/ml to 0.25 mg/ml (e.g. 72 mg in 500 ml to 250 mg in 1 litre), administered over thirty minutes to one hour.
Ceftazidime: Doses in the range 250 mg to 2000 mg reconstituted with Water for Injections as recommended by the manufacturer (e.g. 2.5 ml for 250 mg and 10 ml for 2 g ceftazidime) and given as an intravenous bolus injection over approximately five minutes.
Cyclophosphamide: Doses in the range 100 mg to 1 g, reconstituted with Water for Injections, 5 ml per 100 mg cyclophosphamide, as recommended by the manufacturer and given as an intravenous bolus injection over approximately five minutes.
Doxorubicin: Doses in the range 10-100 mg reconstituted with Water for Injections, 5 ml per 10 mg doxorubicin, as recommended by the manufacturer and given as an intravenous bolus injection over approximately 5 minutes.
Dexamethasone: Dexamethasone sodium phosphate 20 mg may be administered as a slow intravenous injection over 2-5 minutes via the Y-site of an infusion set delivering 8 or 16 mg of Ondansetron Teva over approximately 15 minutes. Compatibility between dexamethasone sodium phosphate and ondansetron has been demonstrated supporting administration of these drugs through the same giving set resulting in concentrations in line of 32 microgram - 2.5 mg/ml for dexamethasone sodium phosphate and 8 microgram – 1 mg/ml for ondansetron.
How to store Ondansetron Teva
Shelf life before opening: 3 years
Store Ondansetron Teva in the original aluminium overpouch in order to protect from light. Do not freeze.
After opening: Chemical and physical in-use stability has been demonstrated for 24 hours at 20±5°C temperature and normal indoor illumination, thus no protection from normal indoor light is necessary while infusion takes place.
From the microbiological point of view, the product should be used immediately. If not used immediately, in-use storage times and conditions prior to use are the responsibility of the user and would normally not be longer than 24 hours at 2 to 8°C, unless opening has taken place in controlled and validated aseptic conditions.
Disposal of Ondansetron Teva
Any unused product or waste material should be disposed of in accordance with local requirements.